top of page

MIMAKI PLOTTERS

Mimaki CG-SRIII Series

The Mimaki CG-SRIII Series of roll-based cutters are available in three widths. These models feature continuous crop mark detection for precise contour cutting. A proprietary half cut function leaves a small bit of backing sheet at connecting points for easier handling. Accurate long-length cutting is enabled through segment compensation. These cutting plotters are ideal for producing decals, stickers, cut-vinyl signs and more.

  • Three sizes available:

    • CG-60SRIII: 29.1 inches (74 cm)

    • CG-100SRIII: 49.2 inches (125 cm)

    • CG-130SRIII: 61 inches (155 cm)

  • Continuous crop mark detection

  • Half cut function

  • Segment compensation

  • Over cut function

  • Three selectable job speeds

  • Media load from front or back

  • Remote event notification function

  • FineCut8 and SimpleCut software included

Mimaki CG-FXII Series

The Mimaki CG-FXII Series of roll-based cutters are available in two widths. These models feature high speed, continuous crop mark detection for precise contour cutting. A proprietary half cut function leaves a small bit of backing sheet at connecting points for easier handling. An over cut function makes a cross cut at the start and end positions, resulting in sharp edges with no undercut fragments. These models are ideal for producing decals, stickers, cut-vinyl signs and more.

  • Two sizes available:

    • CG-130FXII: 62 inches (158 cm)

    • CG-160FXII: 74 inches (188 cm)

  • High speed, continuous crop mark detection

  • Half cut function

  • Over cut function

  • Selectable clamp pressure

  • Three selectable job speeds

  • Media load from front or back

  • FineCut8 software included

bottom of page